This be mini size power amplifier 2
watt OTL that use IC LM380.
Be base readymade circuit for side sound work and the communication. Which use
outside equipment adds least. The C6 can choose get many the value since 47uF
to at 470uF which , have a voice good bass. The C3 use for decrease tall
frequency or noise. It be valuable stay between 0.0047uF sections arrive at
0.047uF. And use to The 12V power supply (8V to
12V) from , car battery or the other.The Pin 3,4,5,10,11 legs and 12 soldered
directly with copper side of PCB. Which use replace Heat sink The detail is
other , see in the circuit.
Mini amplifier for computer
music
This is mini old amplifier circuit
that used an Op-Amp Audio Amplifier at have strip zone frequency wide. It
develop upward for apply to change digital signal to analog signal circuit
(DAC) and change low filter circuit . For be born the sound of music. Which
build by Chinese gambling cow staggers to stagger, By the circuit composes
op-amp IC LM3900 perform amplify at the beginning, as a result driver
the sound with dual transistor subsequently submit go to still a loudspeaker
next. see other detail in the circuit.
High volt mini
Amplifier with UJT transistor
This be power amplifier circuit it
work with high volt power supply about 125V directly. It composes UJT
transistor and transistor the ordinary. This circuit uses transformer sing bail
with then apply to high volt and use a loudspeaker has easy. It then get into
trouble a little. You can fine to decorate the popularity has of the sound with
VR1 – 1M. Read the detail adds in the circuit.
You
can use this powerfull amplifier in any small audio project. It is very small
(6.5 x 4.5 cm).It outputs 10W and uses a 9V battery.
Componets
Layout
PCB
Component
R1 : 6 Ohm
|
R2 : 220 Ohm
|
R3 : nothing
|
R4 : 10 KOhm pontesiometer
|
C1 : 2200 uF / 25V
|
C2 : 470 uF / 16V
|
C3 : 470 nF / 63V
|
C4 : 100 nF
|
C5 : nothing
|
C6 : nothing
|
IC1 : TDA 2003
|
http://www.hubcity.net
No comments:
Post a Comment