Motorola
Hi-Fi power amplifier
This is a very simple, low cost, Hi-Fi quality power
amplifier. You can build it 5 ways, like it’s shown in the
table (from 20 W to 80 W RMS).
Some comments:
- The first thing that you must do, is to measure the end transistors (T3 and T4) amplifying coefficient, the hfe or β. If their disagreement is bigger than 30 %, the amplifier would not give a clear sound. I used MJ3001 and MJ2501 transistors, and this disagreement was around 5%.
- Before the first “turning on” you must short circuit the inputs of the amp, and put a mA-meter on the output, than turn the amplifier on, and tune the R13 pot, to decrease the DC current on the output, to some uA-s, or in a lucky situation to zero. I was able to decrease it to 10 uA.
- The first thing that you must do, is to measure the end transistors (T3 and T4) amplifying coefficient, the hfe or β. If their disagreement is bigger than 30 %, the amplifier would not give a clear sound. I used MJ3001 and MJ2501 transistors, and this disagreement was around 5%.
- Before the first “turning on” you must short circuit the inputs of the amp, and put a mA-meter on the output, than turn the amplifier on, and tune the R13 pot, to decrease the DC current on the output, to some uA-s, or in a lucky situation to zero. I was able to decrease it to 10 uA.
This amplifier can be used as a stereo or mono power amplifier. Used as a stereo amplifier this will deliver a solid 60 Watts per channel or in mono mode will deliver 110 Watts (8 ohms). With PSX-R up...
Our
monobloc power amp provides the ultimate system performance. Cyrus designed
Zero-feedback technology and bespoke power supply componentry provides a
massive 150watt burst power for truly enthralli...
<sub3<
sub="">
</sub3<>
-
It gives a very good sound
quality.
No comments:
Post a Comment